Table of Contents
Advertisement
INSTALLATION OF FASTENING PLATES
Fasten the plate provided to the
post (fig. 1)
Anchor the rear part of the piston to
the plate and fasten it firmly (fig. 2).
(FIG. 2)
Warning! When establishing the height off the ground at which to fasten the plate to the post
(fig. 1), keep in mind that the plate for anchoring the piston to the gate must be fastened at the
same level (fig. 3)
Installing the anchor plate on the piston to the gate
1. Fit the anchor plate onto the piston (fig. 4)
2. Close the gate
3. Move the piston with the plate already
fitted towards the gate
4. Move the fitting to limit stop, then move it
back by approximately 1 cm and mark the
position of the plate.
5. realize the same operation in opening.
6. If positions correspond, fix the plate on the
gate; otherwise revise A and B units
(table 1)
Release procedure
Open the plug located
underneath on the lower
part of the piston, insert
the key provided and turn
clockwise
(FIG. 1)
(FIG. 3)
(FIG. 4)
Advertisement
Table of Contents
