Acer GT7700-UQ9300A User Manual page 75

5 If you are replacing a hard disk, remove the four screws that secure the hard disk to
the carrier (1), then remove the disk from the carrier (2).
6 Keep the screws for later installation.
To install a new hard drive to an empty carrier:
1 Perform steps 1 through 5 of the previous section.
2 Remove the four screws. Save the screws for later use.
3 Remove the new HDD from its protective packaging.
4 Install the new hard disk into the HDD carrier. Secure it with the four screws you
removed.
5 Install the new hard drive into the drive bay.
a Slide the drive into the bay with the carrier handle still extended.
63