Brewing Cappuccino; Frothing Milk - Philips HD8830 Manual

1
2 1
Memo
Cappuccino
4 To remove the automatic milk frother, press the release buttons on both
sides of the automatic milk frother, lift it slightly and pull to remove it.

Brewing cappuccino

Warning: Danger of scalding! Dispensing may be preceded by
small jets of hot water. Wait until the end of the brewing cycle
with removing the automatic milk frother.
Caution: Steam and hot milk may spray out of the milk froth dispensing
spout at the start of the brewing cycle.
Note: Use cold milk (at a temperature of approximately 5°C/41°F) with a
protein content of at least 3% to ensure an optimal frothing result. You can
use whole milk or semi-skimmed milk. It is also possible to use skimmed
milk, soy milk and lactose free milk.
1 Place a large cup under both the automatic milk frother and the coffee
dispensing spout.
2 Remove the lid of the milk carafe and pour the milk in the milk carafe.
Close the lid of the milk carafe.
3 Insert the other end of the suction tube into the milk carafe till the
bottom of the milk container.
4 Press the CAPPUCCINO button.
-
The machine dispenses first the milk and then coffee.
5 Remove the milk tube connector from the automatic milk frother.
6 Plug the milk connector to the pin on the milk container lid and put the
milk container in the fridge.
Note: After brewing a milk-based beverage perform a quick clean of the
milk circuit. Dispense hot water for 5 seconds, see chapter 'Maintenance
and care', section 'Quick clean of the milk system'.

Frothing milk

1 Place a large cup under the automatic milk frother.
2 Remove the lid of the milk carafe and pour the milk in the milk carafe.
Close the lid of the milk carafe.
3 Insert the other end of the suction tube into the milk carafe till the
bottom of the milk carafe.
English
17