Circuit Priming - Philips HD8830 Manual

1
2

Circuit priming

4 Open the lid of the bean hopper. Fill the bean hopper with coffee beans
and close the lid.
Note: Do not overfill the bean hopper to avoid damage to the grinder.
Caution: Only use espresso beans. Never use ground coffee, unroasted
coffee beans or caramelized coffee beans, as this may cause damage to
the machine.
Note: Do not add pre-ground coffee, water or coffee beans in the coffee
exit duct.
5 Insert mains plug into a wall socket (1) and insert the small plug into the
socket located on the back of the machine (2).
6 Set the main switch to the ON position to switch on the machine.
7 Insert the hot water dispensing spout.
8 Press the ON/OFF button to switch on the machine.
During the initial heat-up process, fresh water flows through the internal
circuit to heat up the machine. This takes a few seconds.
1 Place a container under the hot water dispensing spout.
English
11