Installing Gas Cylinder; Gas Regulator - Uniflame GBC1768WE-U Owner's Manual

14
To operate you will need a precision-filled gas cylinder between 11kg and 15kg. Your barbecue is supplied with a regulator and hose suitable for
use with a propane patio gas cylinder with a 27mm connection.
Place Gas Cylinder
Read thoroughly before use.
Gas Regulator Parts
1 Regulator Identification Label
2 Regulator Assembly
3 Regulation Rubber Hose
4 Hose Clamp
5 Regulator Valve Handle
Connecting and Operating Conditions
The regulator supplied is a 27mm "Snap on compact" propane regulator operating at 37 mbar pressure.
The "Snap on compact" is a regulator designed to supply gas to a consuming appliance at a pressure
and capacity as indicated on the regulator identification label.
The "Snap on compact" can be fitted to any cylinders equipped with automatic valves having a
diameter as indicated on the regulator.
W CAUTION: The gas cylinder must always be used in the upright position.
W CAUTION: Whenever used outdoors, the "snap on compact" should be
protected against rain.
W CAUTION: Never use a flame to look for leaks, do it using a soap solution.
W CAUTION: In case of any difficulties or problems, close the gas supply
immediately and contact your dealer.
W CAUTION: Never move or displace the gas cylinder when it is on.
W CAUTION: Gas cylinder must be properly disconnected and removed prior to
moving this grill.
W CAUTION: Never attempt to disconnect regulator when the regulator valve is
not in the "OFF" position.
W CAUTION: If you are unable to turn the regulator handle to the "ON" position,
your regulator is not properly connected. Do not force the handle to open.
Remove the regulator and repeat "Connect Gas Cylinder" section.
Installing LP Gas Cylinder
W Gas cylinder must be properly disconnected

Gas Regulator

Figure A
1
5
CAUTION
and removed prior to moving this grill.
< ø33 cm
3
4
2
.
Figure B
Figure C
Figure D