Installing Gas Cylinder - Uniflame GBT1712W-U Owner's Manual

Portable gas bbq grill
Table of Contents

Advertisement

8
To operate you will need a precision-filled gas cylinder between 11kg and 15kg . Your barbecue is supplied with a regulator and
hose suitable for use with a propane patio gas cylinder with a 27mm connection .
W Gas cylinder must be properly disconnected
and removed prior to moving this grill.
Place Gas Cylinder
Read thoroughly before use.
Gas Regulator Parts
1
Regulator Identification Label
2
Regulator Assembly
3
Regulation Rubber Hose
4
Hose Clamp
5
Regulator Valve Handle
Connecting and Operating Conditions
The regulator supplied is a 27mm "Snap on compact" propane regulator operating at 37 mbar pressure .
The "Snap on compact" is a regulator designed to supply gas to a consuming appliance at a pressure and capacity as indicated on the regulator
identification label .
The "Snap on compact" can be fitted to any cylinders equipped with automatic valves having a diameter as indicated on the regulator .
W CAUTION: The gas cylinder must always be used in the upright position.
W CAUTION: Whenever used outdoors, the "snap on compact" should be protected against rain.
W CAUTION: Never use a flame to look for leaks, do it using a soap solution.
W CAUTION: In case of any difficulties or problems, close the gas supply immediately and contact your dealer.
W CAUTION: Never move or displace the gas cylinder when it is on.
W CAUTION: Gas cylinder must be properly disconnected and removed prior to moving this grill.
Fitting the Hose
Before connecting the "Snap on compact" to a cylinder valve:
1 .
Connect regulation rubber hose to the barbed stem on the regulator .
Tip: Lubricate the barbed stem with water to help connect the regulator hose to the regulator .
2 .
Use a hose clamp to secure the regulation rubber hose to the regulator .
Connect Gas Cylinder
1 .
Make sure control knobs are
2 .
The regulator rubber hose and regulator are properly and securely connected .
3 .
The regulator valve handle is in the "OFF" position . (Figure C) .
4 .
Remove the seal cap from the automatic valve on the gas cylinder .
Installing LP Gas Cylinder
CAUTION
.
Figure A
1
5
(OFF) position (Figure 1) .
Gas Regulator
3
4
2
< ø33 cm
CAUTION
W Never attempt to disconnect regulator when the
regulator valve is not in the "OFF" position.
Figure B
K
F
AA
Figure C
Figure D
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents