Restoring Factory Default Settings - Nisuta NS-KVMUV8 User Manual

NS-KVMUV8 / NS-KVMUV16 User Manual

Restoring Factory Default Settings

You can restore the factory default settings (listed on the next page) for the
NS-KVMUV8 / NS-KVMUV16. With this procedure, the administrator and
all user accounts are removed from the system. All port names and setting are
also removed.
Note: A jumper cap is required when performing this procedure.
1. Unplug the NS-KVMUV8 / NS-KVMUV16 power adapter.
2. Remove the cover of the NS-KVMUV8 / NS-KVMUV16.
3. Depending on the model, place a jumper cap over pins 1-2 of the J17 or
J10 jumper on the mainboard.
J10
4. Plug in the NS-KVMUV8 / NS-KVMUV16 power adapter. The following
directions appear on the KVM console screen:
USERNAME AND PASSWORD INFORMATION AND PORT/USER
INFORMATION HAS BEEN CLEARED. PLEASE POWER OFF THE
SWITCH, REMOVE THE JUMPER, CLOSE THE CASE, THEN
RESTART.
5. Unplug the power adapter again.
6. Remove the jumper cap from pins 1-2 of the J17/J10 jumper.
7. Replace the cover on the KVM switch.
8. Plug in the NS-KVMUV8 / NS-KVMUV16 power adapter.
9. You should now use the default username and password to log in to the
NS-KVMUV8 / NS-KVMUV16.
51
J17