Components; Front View - Nisuta NS-KVMUV8 User Manual

Components

Front View

Note: The NS-KVMUV16 is pictured above. The NS-KVMUV8 front panel is the
same as the NS-KVMUV16, except that it has 8 KVM port LEDs instead
of 16.
No. Component
1 Port LEDs
2 Reset Button
3 Firmware
Upgrade
Recovery
Switch
4 Firmware
Upgrade Port
5 Power LED
1 2
These port selection pushbuttons each contain 2 LEDs.
An orange LED indicates that a computer is connected to
the corresponding port.
A green LED indicates that the computer connected to the
corresponding port has focus.
Simultaneously pressing port LEDs 1 & 2 resets the
console keyboard and mouse.
Simultaneously pressing port LEDs 7 & 8 on the NS-KVMUV8 /
NS-KVMUV16 , or 15 & 16 on the NS-KVMUV16, starts Auto
Scan mode. See F7: SCAN, page29.
Pressing in this button performs a system reset. When the
system is reset, the NS-KVMUV8 / NS-KVMUV16 beeps, and
then the KVM port LEDs flash in succession until the reset is
completed. After the reset is completed you can login again.
Note: This button is semi-recessed and must be pushed with a
small object, such as the end of a paper clip or a ballpoint pen.
During normal operation and whil e performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery , page46, for details.
The firmware upgrade cable that transfers the firmware
upgrade data from the administrator's computer to the
NS-KVMUV8 / NS-KVMUV16, plugs into this RJ-11 connector.
Lights to indicate that the unit is receiving power.
Chapter 1. Introduction
3 4
Description
5
5