Stihl FS 235 R Instruction Manual page 11

6 Assembling the Trimmer
6.2 Mounting the Loop Handle
► Shut off the engine.
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
drive tube (5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle
(3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
6.3 Mounting Loop Handle with
Barrier Bar
► Shut off the engine.
1 2
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8) firmly.
6.4 Mounting and Removing the
Deflector
6.4.1 Mounting the Deflector
► Shut off the engine.
0458-500-0121-B
1
2
3
4
5
6
7
3 4
5
6
7
8
2
► Push the deflector (1) into the guides on the
gear housing as far as stop.
► Insert and tighten down the screws (2) firmly.
6.4.2 Removing the Deflector
► Shut off the engine.
► Take out screws.
► Remove guard.
6.5 Fitting and Removing the Skirt
6.5.1 Fitting the Skirt
► Shut off the engine.
1
2
► Slide the guide slot in the skirt (2) onto the
deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.5.2 Removing the Skirt
► Shut off the engine.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the
deflector.
The line limiting blade (1) can be left on the skirt.
English
1
3
4
2
1
11