Advertisement
3.
OPERATION
3.1.
Ensure all measuring surfaces are clean and then turn on calliper by pressing
'ON' button. Wait at least one second before use.
3.2.
Loosen locking screw and close calliper; if read-out does not show zero when
in closed position, reset by pressing 'Zero' button.
3.3.
Select inch or mm units, as required, with the metric/imperial selector. Check
that display shows the required units.
3.4.
Measurements will now be shown directly on the LCD display.
3.5.
A new zero may be obtained, at any open position of the calliper, by pressing
the zero control.
3.6.
When finished, turn off and store calliper in a safe, dry, childproof location.
4.
MAINTENANCE
4.1
BATTERY INSTALLATION/REPLACEMENT
NOTE! The battery should last for one year of continuous use. If the display is blank
or the digits are flashing the battery voltage is too low, replace the battery with a new
SR44 power cell. If the digits do not change when buttons are pressed or probe is
moved, remove the battery for 1 minute to reset the unit. The battery should be
removed if the gauge is not to be used for a long period of time.
4.1.1.
Lift off the battery cover (fig 2) after removing the two screws.
4.1.2.
Remove exhausted battery and fit replacement with +ve side uppermost and
fix the cover back into place using the two screws.
4.1.3.
Dispose of old battery in a safe and approved manner. Do not burn.
If the display fails to alter when the slide is moved, remove the battery, wait
at least 1minute and then refit the battery.
Fig 2
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Do not incinerate battery as it may explode when exposed to fire.
Do not attempt to open battery.
Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Environmental Protection.
Sole UK Distributor,
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 703534
Web
01284 757500
E-mail: sales@sealey.co.uk
www.sealey.co.uk
Advertisement
