AAA-055-00084
SHEAR BOLT PROTECTED DRIVELINE
Should excessive loads be placed on the driveline, the shear bolt will rupture. This is a safety
feature; however, do not depend on this as the maximum load indicator. The shear bolt is located
on the gearbox end of the driveline shaft supplied with the machine. If the shear bolt breaks, it
must be replaced with the correct bolt specified by the manufacturer. Refer to the 'Maintenance
and Service Information' attached for details. For convenience, spare shear bolts are supplied
with the machine and are stored on the left side of the hood as directed in the above diagram.
Figure 9 Shear Bolt Location
FRONT DOOR DISCHARGE CONFIGURATIONS
Front Door Discharge
The front discharge door is controlled hydraulically from the tractor. The door is opened to allow
feed out of the mixing chamber onto the conveyor.
The door can be raised to any position up to a maximum of 32 inches (81 cm) in height. Use the
door guide markings to determine the door opening height.
Jaylor Operator's Manual
- 29 -
Twin Auger Trailer Units