Service And Maintenance - Craftsman CMXGMAM1125505 Instruction Manual

Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting.
Interval
First Five Hours
Each Use
Annually or 50 hours
Annually
Before Storage
* Clean more often under dusty conditions or when airborne debris is present. Replace air cleaner if very dirty.
Always stop engine, allow engine to cool, disconnect spark plug wire, and
ground against engine before performing any type of maintenance on your
machine.
General Recommendations
• Always observe safety rules when performing any maintenance.
• The warranty on this lawn mower does not cover items that have been
subjected to operator abuse or negligence. To receive full value from
warranty, operator must maintain the equipment as
instructed here.
• Changing of engine-governed speed will void engine warranty.
• All adjustments should be checked at least once each season.
• Periodically check all fasteners and make sure these are tight.

SERVICE AND MAINTENANCE

MAINTENANCE SCHEDULE
WARNING
Item
1. Engine Oil (See engine manual)
1. Engine oil level (See engine manual)
2. Loose or missing hardware
3. Unit and engine
1. Air cleaner * (See engine manual)
2. Engine Oil (See engine manual)
3. Control linkages/pivots and wheels
4. Underside of mower deck
1. Spark plug (See engine manual)
2. Air Cleaner (See engine manual)
1. Fuel system
WARNING
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest Service Center or to schedule service, call
the following toll free number:1-888-331-4569.
See the Engine Operator's manual packed with the mower for detailed instructions
on how to perform many of the following maintenance items.
Service
1. Change
1. Check
2. Tighten or replace
3. Clean
1. Clean
2. Change
3. Lube with light oil
4. Clean
1. Replace
2. Replace
1. Run engine until it stops from lack of fuel, or
add stabilizer to a full tank of fresh fuel prior
to storage.
Lubrication
Blade Control
Lubricate pivot points on the blade control at least once a season with light oil. This
control must operate freely in both directions. See Figure 14.
14
Service Log
Figure 14