Unpacking; Assembly - Craftsman CMXGMAM1125505 Instruction Manual

IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain
to service engine with gasoline and oil as instructed in the Operation section of the
Engine Manual before starting or running your machine.
NOTE: Reference to right and left hand side of the Lawn Mower is observed from the
operating position.

Unpacking

Opening Carton
1. Cut each corner of the carton vertically from top to bottom.
2. Remove all loose parts.
3. Remove loose packing material.
Removing Unit From Carton
1. Lift unit from the rear to detach it from underlying carton material and roll
unit out of carton.
2. Check carton thoroughly for any other loose parts.
Loose Parts In Carton
• Grass Catcher
• Side Discharge Cover
• Engine Oil

Assembly

Handle Setup
1. Remove any packing material which may be between upper and lower
handles.
a. Remove the T-bolts from the handle brackets as shown in Figure 1.
b. If necessary, place the release levers in the unlocked positions. See
Figure 1.
NOTE: On select mowers, the EZ-Fold handle release levers are shipped in the
unlocked positions. Proceed to Step 3.
a
a
b
b
b
Figure 1
ASSEMBLY
3. While stabilizing mower so it doesn't move, lift the upper handle up as
shown in Figure 2. Do not crimp cable while lifting the handle up.
4. Make certain the lower handle is seated securely into the handle brackets.
NOTE: When lifting the upper handle ensure the position indicator aligns with one
of three handle positions. See Figure 2 inset.
Handle Positions
5. Place the release levers in the locked position. See Figure 3.
6. Insert the T-bolts removed in Step 1a through the handle brackets and lower
handle and tighten securely to secure the handle in place. See Figure 4.
b
8
Position
Indicator
Figure 2
Figure 3
Figure 4