Canon imageFORMULA DR-C230 User Manual page 61

Launch method setting
By default, CaptureOnTouch becomes resident in the system when
you start your computer. Clear the [Make CaptureOnTouch resident]
check box to not make CaptureOnTouch resident in the system.
Display setting for when scanner connected
Select the [Launch CaptureOnTouch when scanner is connected]
checkbox to open the main screen of CaptureOnTouch automatically
when the scanner is connected to the computer. This setting is only
enabled when CaptureOnTouch is running (or resident in the system).
If the [Do not display the main screen when the scan is started with the
scanner button] check box is selected, the main screen of
CaptureOnTouch is not displayed when the Scanning Shortcut
scanning is started by pressing the scanner's Start button. However,
dialogs and error messages during scanning and the pop-up screen
when the scan is completed will be displayed.
When this setting is enabled, the [Enable additional scan] and [Edit
after scanning] check boxes on the Edit Scanning Shortcut settings
screen are disabled.
Back Up / Restore
Use the [Back Up] and [Restore] buttons to back up the configuration
file (settings, registered jobs, etc.) of CaptureOnTouch and restore the
settings from the backup data.
[Back Up] button
Back up the settings of CaptureOnTouch to a backup file (*.plist). You
can store the initial settings of CaptureOnTouch by performing a
backup before you first use CaptureOnTouch.
[Restore] button
Restore the settings from the backup file.
When using multiple computers, you can back up the environmental
settings of one computer and then perform a restore on the other
computers so that all of the computers have the same settings.
[Plugin] Tab
On the [Plugin] tab, confirm the plugins that have been added to
CaptureOnTouch.
[Setting] button
Displays the detailed information on the selected plugins.
Hint
This button may not be displayed for some plugins.
[Enable] [Disable] button
This button is used to toggle between Enable/Disable modes for the
plugin selected from the plugin list.
[Maintenance]Tab
On the [Maintenance] tab, configure the following settings.
[Initialize]
Return all settings to their default condition.
60