Programming A/B Instant Access Buttons; Operation Of A/B Instant Access Buttons - Entel HT840 Owner's Manual

2.3.1 PROGRAMMING A/B INSTANT ACCESS BUTTONS

1. Hold down the [A/B] key and turn on the transceiver.
2. The letter A will appear on the display, and dashes "_ _"
indicate that no channel has been designated channel A.
3. Press the [UP/DOWN] key until the desired channel number is
displayed.
4. With the desired channel number displayed, press the [MEM]
key once. The "A" will stop flashing, indicating that the displayed
channel is now designated channel A.
5. Press the A/B button again. The letter "b" will appear on the
display. Repeat steps 2 through to 4.
6. Switch transceiver off and on to exit this mode and save
changes.
NOTE: Should you later wish to delete any stored channels simply
press "MEM" key whilst in A/B programming mode.

2.4 OPERATION OF A/B INSTANT ACCESS BUTTONS

Pressing the [A/B] button will toggle between A, B and the previous
selected working channel. Channel A is represented by the "A"
to the left of the channel number on the LCD, and channel B
is represented by "b". NOTE: Do not confuse this "A" with the one
that is sometimes displayed to the right hand side of the channel
number (in U.S.A and Canadian modes)
14