Noaa Weather Channels; Scan - Entel HT840 Owner's Manual

1.9 NOAA WEATHER CHANNELS

(Applicable to version A model only)
1. To receive a weather channel, press the [WX] key.
The transceiver enters into weather channel mode.
2. There are 10 weather channels. Use the UP or DOWN buttons
to select the desired weather channel.
3. To exit from the weather channels, press the [WX] key.
The transceiver recalls the previous working channel.

2.0 SCAN

1. Select the desired channel to be scanned using
the & buttons.
2. Press the [MEM] button to store the channel into the transceivers
memory. [MEM] is displayed on the LCD.
This channel is now memorised to be scanned.
3. To scan further channels, repeat steps 1 & 2.
4. To delete a channel from the transceivers scan memory,
simply press [MEM] button again whilst the memorised channel
is displayed. [MEM] disappears.
5. All channels programmed remain in the transceivers scan
memory, even if the power is switched off.
6. Adjust the squelch control until the white noise is eliminated.
7. To start scanning, press the [SCAN] key. The scan proceeds from
the lowest to the highest programmed channel number and
stops on channels when a transmission is received.
8. To stop the scan at any time, press the [SCAN] key.
12