Installation Instructions; Electrical Connection - CANDOR VINORUM JC-135A2E/HC User Manual

Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for approximately 4 hours. This will reduce
the possibility of a malfunction in the cooling system from improper handling during transportation. Clean the interior
surface with lukewarm water using a soft cloth. (Cleaning instruction on page 9)
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and Keep ventilation openings in the unit enclosure or in the built-in
structure clear of obstructions
Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper air ventilation. Adjust
the feet to keep the wine cooler level. Locate the wine cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Ambient temperature below 5°C or above 32°C will hinder the performance of this appliance.
Depending on the location of the appliance, the direction in which the door opens can be changed.
This unit is not designed for use in a garage or any other outside installation.
Do not position the wine cooler in a damp or humid environment.
Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any circumstances cut or remove
the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed
toward a certified electrician or an authorized service center.
This unit is not designed to be installed in an RV or used with an inverter, for indoor use only.
After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool down for 3 ~ 4 hours under
before placing wine bottles or beverages in the appliance.
WARNING: Keep ventilation openings in the appliance enclosure, clear of obstruction.

Electrical Connection

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it
replaced by an authorized service center.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by
the manufacturer.
Do not damage the refrigerant circuit (The refrigerant is a very environmental-friendly gas but is also combustible. Take
care when transporting or moving the unit to ensure that the refrigeration circuit is not damaged. In the event of damage
avoid naked flames or ignition sources and ventilate the room in which the unit is placed for a few minutes.)
When positioning the appliance, ensure the supply cord is not trapped or damaged.
Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type
recommended by the manufacturer.

INSTALLATION INSTRUCTIONS

WARNING: Risk of fire/flammable materials
WARNING
 
32