Table of Contents
Advertisement
Instructions for Use
a. Normally the wearable device is placed on the outer side of the upper left
arm. It should be placed high enough above the elbow to minimize
disturbance when the arm is bent.
b. The placement may be rotated towards the rear of the arm if this is helpful,
but do not place the device to the inside of the arm. If the left arm is absent,
is bandaged, has broken skin, a tattoo, or shows localized edema, the device
may be worn on the right arm
c. Check the patient's skin, particularly the area where the sensors will be.
Consider adjusting the location to avoid the following features:
i. Particularly hairy areas
ii. Moles or areas of raised skin
iii. Deep wrinkles, areas of pitted skin or scar tissue
iv. Tattoos or areas of strongly varying skin colour
2. Measure the patient's arm size, and use an appropriate size of strap for that patient.
3. Fit the device into the strap, ensuring the arrows are aligned and the ring sits into
the notches on the device. Thread the strap through the eyelet on the other end of
the strap and slide up the patient's arm.
www.currenthealth.com
200002/1
Page 33 of 61
Advertisement
Table of Contents
