EIBENSTOCK EBM 352/3 Original Instructions Manual page 21

During work, always lead the mains cable, extension cable and extraction

hose to the back away from the machine.
Power tools have to be inspected visually by a specialist in regular

intervals.
When using the drill, cooling water is never allowed to get into the

motor and all electrical parts.
Overhead-drillings only with suitable safety measures (water collection).

After an interruption of your work, only switch the machine on again after

having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.

Do not touch rotating parts.

Persons under 16 years of age are not allowed to use the tool.

During use, the user and other persons standing nearby have to wear

suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when

you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
98
79,5
Fasten the gearing foot of the
EBM 352/3 by means of four M 8 Allen
screws to the drill rig.
The drill stand should have a good
stiffness and precise guide ways. The
spindle of the machine needs to go
parallel to the axle of the drill stand.
Use only fall-safe drill rigs.
It is advisable to use a water-collecting
ring.
The EBM 352/3 is equipped with a
transport handle
transport of the core drill and inserting in
the drill rig reception easier.
21
which makes the