Table of Contents
Advertisement
17. TRACTOR, BOOM, AND ATTACHED HEAD STORAGE
Properly preparing and storing the unit at the end of the season is critical to maintaining its appearance and to
help ensure years of dependable service. The following are suggested storage procedures:
•
Thoroughly clean all debris from boom and
head to prevent damage from rotting grass and
standing water.
•
Lubricate all grease points and fill oil levels
according
to
the
schedule.
•
Tighten all bolts to the proper torque. Ensure all
pins and other hardware are in place.
•
Check the boom arm and head for worn and
damaged parts. Perform repairs and make
replacements so that the mower will be ready
for use at the start of the next season.
•
Store the unit in a clean and dry location.
•
Use spray touch-up enamel where necessary
on bare metal surfaces to prevent rust and to
maintain the appearance of the mower.
OPS-B- 0012_H
Never allow children to play on or around Tractor or Implement. Children can slip or fall off
the Equipment and be injured or killed. Children can cause the Implement to shift or fall
crushing themselves or others.
BEFORE leaving the tractor seat lower the implement, set the parking
brake and/or set the tractor transmission in parking gear, disengage the
PTO, stop the engine, remove the key, and wait for all moving parts to
stop. Place the tractor shift lever into a low range or parking gear to
prevent the tractor from rolling. Never dismount a Tractor that is moving
or while the engine is running. Operate the Tractor controls from the
tractor seat only.
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
RMB 1865 11/10
© 2010 Alamo Group Inc.
OPERATION
maintenance
lubrication
(SG-9)
(S3PT-15)
Operation Section 4-36
(SG-25)
Advertisement
Table of Contents
