Installation Guide; Grounding Instructions - Oster OGB7901 User Manual

INSTALLATION GUIDE

1. Make sure all packing materials are removed from inside the microwave door.
2. Check the microwave for damage, such as misaligned or bent door, damaged door seals and sealing surface,
broken or loose door hinges and latches, and dents inside the cavity or on the door.
3. This microwave must be placed on a flat, stable surface to hold its weight and the heaviest food likely to be
cooked inside.
4. Do not place the microwave where heat, moisture, or high humidity is generated. Do not place microwave near
combustible materials.
5. For correct operation, the microwave must have sufficient air flow. Allow 8" of space above the microwave, 4" at
the back, and 2" on each side of the unit.
6. Do not cover or block any openings on the microwave. Do not remove microwave feet. Do not operate the
microwave without the glass tray, roller support, and shaft in their proper positions. Make sure the power supply
cord is undamaged and does not run under the microwave or over any hot or sharp surface.
7. The socket must be readily accessible so the microwave can be easily unplugged in an emergency.

GROUNDING INSTRUCTIONS

This microwave must be grounded. In the event of an electrical short circuit, grounding reduces risk of electric shock
by providing an escape wire for the electric current. Consult a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded, and either:
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded, and either:
1) If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and
a 3-slot receptacle that will accept the plug on the appliance. The marked rating of the extension cord shall be equal
to or greater than the electrical rating of the appliance, or 2) Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install an outlet near the appliance
WARNING: Improper use of the grounding plug can result in risk of electric shock.
ELECTRICAL REQUIREMENTS
The electrical requirements for this microwave are a 120V, 60Hz, AC only, 20 amp.
It is recommended that a separate circuit serving only the microwave be provided.
The microwave is equipped with a 3-prong grounding plug. It must be plugged into a wall outlet properly installed
and grounded.
4
.