Table of Contents
Advertisement
3-8
Replacing and Installing the OCP Card (TO22-Z62 Only)
• Voltages can be present within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position. Ensure
that the system is powered-down and all power sources have been disconnected from the
server prior to installing a OCP card.
Failure to observe these warnings could result in personal injury or damage to equipment.
• Before installing the OCP card the left PCI-E riser assembly must be first removed, see
the Installing the PCI Expansion Card section for instructions on removing the PCI-E
riser assembly.
Follow these instructions to install the OCP card:
1.
Romove the HDD Cage. See Section 24 3-2-3 Removing Hard Disk Drive Cage (TO22-Z62
Only) .
2.
Remove the three screws securing OCP card.
3.
Lift up the OCP card.
4.
Remove the screw securing OCP card bracket.
5.
Install the OCP card bracket.
6.
Reverse steps 1 - 4 to install the OCP card into the system.
4
3
System Hardware Installation
1
2
- 32 -
Advertisement
Table of Contents
