Table of Contents
Advertisement
3-8
Installing the Mezzanine Card
3-8-1 Installing the OCP 3.0 Mezzanine Card
Use of the following type of OCP 3.0 NIC is recommended:
• OCP 3.0 SFF with pull tab
• OCP 3.0 SFF with ejector latch
Follow these instructions to install an OCP 3.0 Mezzanine card:
1.
Remove the two screws securing the OCP 3.0 card slot cover.
2.
Remove the slot cover from the system.
3.
Insert the OCP 3.0 card into the card slot ensuring that the card is firmly connected to the connector
on the motherboard.
4.
Tighten the thumbnail screw to secure the OCP 3.0 card in place.
5.
Reverse steps 3-4 to replace the OCP 3.0 card.
1
2
1
3
4
System Hardware Installation
- 39 -
Advertisement
Table of Contents
