Table of Contents
Advertisement
3-2-1 Installing the Hard Disk Drive on the Middle Tray (TO22-Z62 Only)
Read the following guidelines before you begin to install the Hard disk drive:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to install the Hard disk drive:
1.
Remove the System Cover. See Section 3-3 Removing System Cover.
2.
Press the release latch.
3.
Move toward to remove the HDD tray.
4.
Pull apart the hdd tray latch and insert hard disk at a 45 degree.
5.
Pull apart the other side of latch
6.
Push down the and hard disk into the tray.
4
System Hardware Installation
6
5
1
7
- 22 -
3
2
Advertisement
Table of Contents
