Removing Hard Disk Drive Middle Tray (To22-Z62 Only) - Gigabyte TO22-Z61 User Manual

3-2-2 Removing Hard Disk Drive Middle Tray (TO22-Z62 Only)

Read the following guidelines before you begin to install the Hard Drive Moddle Tray:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to install the Hard disk middle tray:
1. Remove the System Cover. See Section 3-3 Removing System Cover.
2. Press the release latch on the both side.
3. Flip over the middle tray.
2
1
- 23 - System Hardware Installation