Table of Contents
Advertisement
5.
Place the 3.5" hot-swap storage
device into the tray then secure it
with four screws.
6.
Insert the tray and storage device
assembly all the way into the depth
of the bay until just a small fraction
of the tray edge protrudes.
When installed, the SATA/SAS/NVMe connector on the storage device connects to the
SATA/SAS/NVMe interface on the backplane.
7.
Push the tray lever until it clicks and
secures the tray in place.
The tray is correctly placed when
its front edge aligns with the bay
edge.
8.
Repeat steps 1 to 7 to install the
other storage devices.
2-18
Chapter 2: Hardware Information
Advertisement
Table of Contents
