Westfalia 82 12 25 Assembly Instruction page 2

Safety Notes
Keep the weed remover out of reach
of children and persons in need of
supervision. The article is not a toy.
The weed remover is not suitable for
rocky or extremely hard soil. Moisten
loamy soil before using the weed
remover. When using the weed
remover on rocky soil, be careful not
do damage the prongs of the weed
remover.
Only use the weed remover for its
intended use, for removing weed. Do
not misuse the weed remover for
loosening the soil.
Assembly
Connect the three parts of the inner
long-hole bar together and make
sure the part A is positioned at the
end of the prongs and part B is at the
end of the handle. The arrows have
to face to each other.
Slide the sleeve over one aluminium
pole.
Insert the already mounted inner bar
in one aluminium pole.
Mount both aluminium
together. Tighten both poles and the
sleeve by using the small screw and
the nut. Make sure the hole in the
aluminium poles is not blocked by the
long-hole bar.
Tighten the trigonal stopper on the
inner pole by using one screw.
Screw the second screw on the
spring-loaded button.
remover is now ready assembled.
Using
Centre the weed remover vertically over the top of the weed and insert the prongs into the soil. Rotate the
weed remover several times to the left and to the right and pull out the weed remover.
Press the spring-loaded button down in order to eject the weed.
Cleaning
Only use a dry or lightly moistened cloth in order to clean the unit. Protect the weed remover from adverse
weather conditions.
Store the weed remover in a dry place out of reach of children and persons in need of supervision. When not
using the weed remover place the protection caps on the prongs.
Design protected by copyright
Weed Remover
Art. 82 12 25
Assembly Instruction
B
A
poles
The weed
Long-
hole
bar
Sleeve
Long-hole bar does
not block the hole
in the poles
Button
Trigonal Stopper
© Westfalia 10/12