Velux INTEGRA V22 Reset

V22 INTEGRA Reset - Window Only Reset - Electric & Solar
All Handsets
Press the reset button on the window. This is located in one of two places dependant on the window
1
type, as below.
For sloping roof windows, push down
on the lever to the right of the T-Bar
and locate the reset button as shown:
2
For flat roof windows, remove the
cover cap on the window frame to
locate the reset button as shown:
Press and hold the reset button for at least 15 seconds (ensure you continue to hold the button
3
even when the chain moves)
Note: If you have other products installed these will also move up and down (e.g. blinds)
4

The chain will move in and out several times.

Once the product stops moving, close the window ensuring the vent bar is fully closed. For electric
5
INTEGRA windows only, switch the power off to the window for at least 60 seconds.
Note: If there is more than one window, repeat the above steps for all windows.
Now, add the 'New' window to the wall switch or handset, as below.
6
Go to Step 7 - 8 Go to Step 9 - 16
Page 1 of 3
Go to Step 17 - 24