Installing Batteries; Using The Ac Adapter - ReliOn WMTBPA-845 Manual

INSTALLING BATTERIES (NOT INCLUDED)
1. Press down on latch and lift the battery cover to open
the battery compartment.
2. Install or replace 4 "AA " sized alkaline batteries in
the battery compartment according to the indications
inside the compartment.
3. Close the battery cover by pushing in the top end of
the battery door.
Replace the batteries if:
• The weak battery symbol appears on the display.
• Nothing appears on the display when the power is
switched on.
Replace all batteries at one time (as simultaneous set).
Use only 1.5V "AA" alkaline batteries. Remove batteries
when unit is not in use for extended periods of time. Date
and time will need to be reset if batteries are removed
or replaced. Clean contacts on battery and in battery
compartment with a soft dry cloth each time you install
batteries.
Note:
Batteries are hazardous waste. Do not dispose of them
together with the household garbage.
Battery
Cover
11

USING THE AC ADAPTER

1. Connect the AC adapter with the AC adapter jack in
the back of the unit as shown below.
2. Please use only the AC adapter included with this
monitor.
Note:
• Please unload the batteries when operating with an
AC adapter for an extended period of time. Leaving
the batteries in the compartment for a long time may
cause leakage, which may lead to damage to the unit.
• No batteries are needed when operating with an AC
adapter.
• Date and time will need to be reset if AC adapter is
unplugged and unit is without batteries.
Connect
AC Adapter
here
AC Adapter
Input: 100-240V~0.18A 50/60Hz
Output: 6V DC 1A 6W Max
12