Gigabyte TRX40 DESIGNARE User Manual page 29

10) LED_C1/LED_C2 (RGB LED Strip Headers)
The headers can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
1
12V
11) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The AMD Chipset supports RAID 0, RAID 1,
and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array.
DEBUG DEBUG DEBUG
PORT PORT PORT
RGB LED
Strip
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATA And RST Configuration," for more information.
DEBUG
PORT
1
LED_C1
1
LED_C2
Connect one end of the RGB LED strip extension cable to the
header and the other end to your RGB LED strip. The black wire
(marked with a triangle on the plug) of the extension cable must be
connected to Pin 1 (12V) of this header. The 12V pin (marked with
an arrow) on the other end of the extension cable must be lined
up with the 12V of the LED strip. Be careful with the connection
orientation of the LED strip; incorrect connection may lead to the
damage of the LED strip.
SATA3 6 4 2 0
7 5 3 1
7
7
Pin No. Definition
1
2
3
4
5
6
7
- 29 -
Pin No. Definition
1 12V
2 G
3 R
4 B
1
1
GND
TXP
TXN
GND
RXN
RXP
GND
Hardware Installation