Gigabyte TRX40 DESIGNARE User Manual page 22

Table of Contents

Advertisement

SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
Tighten the antenna cables to the antenna connectors and then move the antenna to a place
where the signal is good.
Center/Subwoofer Speaker Out
Use this audio jack to connect center/subwoofer speakers.
Rear Speaker Out
Use this audio jack to connect rear speakers.
Optical S/PDIF Out Connector
This connector provides digital audio out to an external audio system that supports digital optical audio.
Before using this feature, ensure that your audio system provides an optical digital audio in connector.
Line In/Side Speaker Out
The line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
Line Out/Front Speaker Out
The line out jack.
Mic In
The Mic in jack.
Audio Jack Configurations:
Jack
Center/Subwoofer Speaker
Out
Rear Speaker Out
Line In/Side Speaker Out
Line Out/Front Speaker Out
Mic In
If you want to install a Side Speaker, you need to retask either the Line in jack to be Side Speaker
out through the audio driver.
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
Hardware Installation
Headphone/
4-channel
2-channel
a
a
a
- 22 -
5.1-channel
7.1-channel
a
a
a
a
a
a
a
a

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents