Table of Contents
Advertisement
6.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
C
INFORMATION
• Repeat Drum Cleaning process in every 2
months.
• Use an anti-limescale suitable for the
washing machines.
After every washing and drying make sure that
no foreign substance is left in the drum.
If the holes on the bellow shown in the figure are
blocked, open the holes using a toothpick.
C
INFORMATION
• Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel. Never use steel wool or wire
wool.
A
CAUTION!
• Never use sponge or scrub materials.
These will damage the painted, chrome
and plastic surfaces.
38 / EN
6.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
6.4 Cleaning the water
intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to enter
the washing machine. Filters should be cleaned
if they are dirty.
1. Close the taps.
2. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean residues on them
with an appropriate brush. If the filters are
too dirty, remove them from their places
with a pliers and clean in this way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters
carefully in their places and tighten
the hose nuts by hand.
Washer-Dryer / User Manual
Hide quick links:
Advertisement
Table of Contents
