Gigabyte R281-Z94 User Manual page 59

iSCSI Parameters via DHCP
Acquires the iSCSI parameters via DHCP.
Options available: Enabled/Disabled. Default setting is Enabled.
CHAP Authentication
Enable/Disable the CHAP authentication.
Options available: Enabled/Disabled. Default setting is Disabled.
Boot to Target
Enable/Disable booting to iSCSI target after log-on.
Options available: Disabled/Enabled/One Time Disabled. Default setting is Enabled.
DHCP Vendor ID
Press [Enter] to configures the DHCP vendor ID (up to 32 bytes long).
Link Up Delay Time
Configures the link up to delay time in seconds (0..225).
Use TCP Timestamp
Enable/Disable the TCP timestamp.
Options available: Enabled/Disabled. Default setting is Disabled.
Target as first HDD
Enable/Disable target appears as a first hard disk drive (HDD) in the system.
Options available: Enabled/Disabled. Default setting is Disabled.
LUN Busy Retry Count
Configures the number of retries in 2 second intervals when LUN is busy (0..60).
Default setting is 0.
IP Version
Displays the IP version supported. Modifying this parameter will reset all IP-related fields.
- 59 - BIOS Setup