Operation of timers
1
2
3
4
5
This section provides timer operation via the unit, but it is possible to
control the timers by using the remote control.
Please ensure that the main power is ON
•
While main power is ON. ON / OFF light glows
green or glows red after ignition.
•
Please ensure the TIMER's are programmed as
per previous section.
Please ensure you take the following steps.
•
Is the gas valve fully opened?
•
Set
temperature?
•
There are no objects in front of the louvre to
block the air outlet.
Press the TIMER/S button/s.
•
You can select TIMER 1 or TIMER 2 or both by
pressing the TIMER 1 and/or TIMER 2 buttons.
•
Selected TIMER's [ON] [OFF] lights will glow.
•
The TIMER operation is not set and will not
function if the TIMER's "ON" and "OFF" lights are
not glowing.
•
If during operation combustion shuts down then
the ON / OFF light will glow green.
Pre-heat function:
[At one hour prior to the set time the heater will
operate automatically – Example; If the ON time is
set for 5.30AM then the heater will automatically
start up at 4.30AM]
•
Selected TIMER 1 or TIMER 2 [ON] light flashes.
•
ON / OFF light turns from green to red.
[Timer operation start time]
•
Selected TIMER's [ON] [OFF] light flash.
18
temperature
is
adjusted
to
desired