Table of Contents
Advertisement
The Screen Menu
For adjusting the size, position, and aspect ratio of the projected image for each input signal.
Setting items
Description
*1
Aspect
Changes the aspect ratio of the projected image (page 30).
When the
Full 1: Displays the image to fit the maximum projected image size without
computer
changing the aspect ratio of the input signal.
signal is
Full 2: Displays the image to fit the maximum projected image size.
input
Normal: Displays the image on the center point of the projected image
without changing the resolution of the input signal or enlarging the image.
When the
4:3: Displays the image to fit the maximum projected image size with an
video signal
aspect ratio fixed to 4:3.
is input
16:9: Displays the image to fit the maximum projected image size with an
aspect ratio fixed to 16:9.
Full: Displays the image to fit the maximum projected image size.
Zoom: Display the center point of the projected image to zoom.
*2 *3
V Center
Adjust the whole projected image by moving up and down on the screen.
As the selected number increases, the screen moves up, and as the selected
number decreases, the projected image moves down.
*2 *3
Vertical Size
Reduces or enlarges the image vertically.
The projected image is enlarged as the setting increases and reduced as the
setting decreases. If the subtitle of a movie, etc. cannot be seen, use this
together with "V Center."
*2
Overscan
On/Off: Hides the outline of the image when set to "On." Select "On" if
noise appears along the edge of the image.
*6
Adjust Signal
Adjusts the image of a computer signal. Use this item if the edge of the
image is cut and reception is bad.
*4 *5
APA
Automatically adjusts the projected image to an optimum quality when you
press the ENTER key.
*4
Phase
Adjusts the dot phase of the display pixel and the input signal. Set to the
value where looks clearest.
*4
Pitch
The higher the setting, the wider the horizontal image elements (pitch). The
lower the setting, the narrower the horizontal image elements (pitch).
*6
Shift
H: The higher the setting, the farther right the image is projected on the
screen. The lower the setting, the image farther left.
V: The higher the setting, the farther up the image is projected on the screen.
The lower the setting, the image farther down.
Notes
*1: • Note that if the projector is used for profit or for public viewing, modifying the original picture
by switching to the aspect mode may constitute an infringement of the rights of authors or
producers, which are legally protected.
• Depending on the input signal or "Screen Aspect" setting, setting items for aspect ratio or
some other setting items cannot be set in some cases, or changing the aspect ratio setting may
have no effect.
• A part of the image may be displayed in black, depending on the setting item.
28
Advertisement
Table of Contents
