Setting-Up - Hitachi YUTAKI Series Service Manual

Controller pack
Service Manual







LCD screen

Battery low indicator

Time display

Burner on indicator

Day indicator

Temperature display

4.22.7.1. Setting-up

This section shows you how to setup and run the Hitachi room unit in 3 simple steps:
STEP 1: Installing the batteries

- Please follow the instructions in this section only if the Hitachi room unit screen is blank (no symbols or digits
are displayed). If the room temperature is already displayed move on to Step 2: Setting the date and time.
To install the batteries:
a. Lift up the front cover of the Hitachi room unit to reveal the battery cover and product controls.
b. Remove the battery cover by pressing down and sliding out.
c. Insert the 2 x AA LR6 Alkaline Batteries supplied with the Hitachi room unit, ensuring the correct orientation (see
'Controls Layout').
d. After a short pause the Hitachi room unit will display information on the screen and is now ready for use.
e. Replace the battery cover by sliding it firmly back into the front of the Hitachi room unit.



1 2 3 4 5
1..6
PROGRAM

Temperature change buttons
 Temperature enquiry button

Operating mode buttons

Green OK button

Battery compartment

Battery cover
note
  
6 7
OFFMAN AUTO

Holiday function button

Program buttons

Copy day button

Set date/Day button

Time change buttons
System MMI Pack (Room unit and RF receiver)





SMGB0066 rev.0 - 12/2009
4
139