Advertisement
Quick Links
Assembly Instructions
CM-BK1035
ASSEMBLY RATING
Tools Required for Assembly:
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
Allen Wrench
(Included)
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
DIFFICULT
EASY
2 PERSONS RECOMMENDED
Page 1 of 12
Rev.14-07-30
Advertisement
Related Manuals for Furniture of America CM-BK1035
Summary of Contents for Furniture of America CM-BK1035
- Page 1 Assembly Instructions CM-BK1035 ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench (Included) assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
- Page 2 Thank you for your purchase! We hope you will enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase.
- Page 3 Page 3 of 12...
- Page 4 Before you begin, please read Page 3 for “Assembly and Care Advice” AND Page 12 for “Safety Warnings”. And remember, do not tighten until each step is completed or instructed. Parts List #2 x 1 pc #1 x 1 pc Right Upper End Rail Left Upper End Rail #3 x 4 pcs...
-
Page 5: Hardware List
Due to the size and/or weight of this product, it is highly recommended that the assembly should be done near the area of its intended location. Make sure you have enough space to move around during the assembly. ALWAYS have at least two people to help with transporting and assembling the product to avoid any potential injury and/or damage. - Page 6 Turn right (clockwise) to tighten Turn right (clockwise) to tighten Page 6 of 12...
- Page 7 Turn right (clockwise) to tighten Turn right (clockwise) to tighten Page 7 of 12...
- Page 8 Turn right (clockwise) to tighten Turn right (clockwise) to tighten Read and follow the information on the WARNINGS shown on the end structure of the upper bunk and on the carton. Do not remove warning label from the bed. Keep Safety is ALWAYS the main priority.
- Page 9 The bunk bed can be converted into two separate twin-size beds. Please follow this section in converting from a bunk bed into two separate beds. Remove the hardware holding the extension poles (#3). Remove the hardware holding the ladder (#9), the rear guardrail (#5) and the front guardrail (#6) and then remove those parts.
- Page 10 Remove the hardware holding the right upper end rail (#2) and the hardware holding the lower end rail (#4). Remove the parts in order to swap locations for the next step. After the parts are swapped, secure the parts Turn right (clockwise) to tighten together using the same hardware.
- Page 11 Insert the 8 covers (#I) as shown below. Safety is ALWAYS the main priority. For extra safety measure and before using the bed, please take the time to inspect the assembly again and make sure that ALL bolts and screws are FULLY tightened.
- Page 12 Safety Warnings for Bunk Beds Read and follow the information on the WARNINGS shown on the end structure of the upper bunk and on the carton. Do not remove warning label from the bed. Keep these instructions for future reference. Always use the recommended size mattress or mattress support, or both, to help prevent the likelihood of entrapment or falls.
Need help?
Do you have a question about the CM-BK1035 and is the answer not in the manual?
Questions and answers