BT BT3110 Quick Setup And User Manual page 5

Quick set-up guide
2. Charge
1. Slide off the battery cover from
the back of the handset and insert
the two batteries supplied. Note the
'+' and '-' markings inside the
battery compartment. Then slide
the battery cover back into place.
2. The handset will check for a link
with the base station. Once found,
you'll need to set the time and date,
but you can then press the [back]
button to skip any further options
until setup is complete (you can
always set these up later).
3. Place the handset on the base
and leave to charge for 16 hours.
Important
Charge the handset batteries for
16 hours or your phone might
not work.
If you need some help, call us on 0800 145 6789 or go to bt.com/bt3110
Talk/Standby time
Under ideal conditions, the
handset batteries should give
up to 10 hours talk time or
100 hours standby on a single
charge. (This doesn't mean you
can unplug the base or leave
the handset for this length of
time without charge).
Please note that new Ni-MH
rechargeable batteries don't
reach full capacity until
they've been in normal use
for several days.
Battery low warning
Battery low warning
You will hear a warning beep
every 2 minutes during a call
and the icon will flash.
You must recharge the
handset batteries before you
can use the handset. If the
charge completely runs out
the handset will switch off.
Place the handset on the
base or charger to charge.
5