Bosch CLIMATE 5000 Service Manual page 33

Outdoor Unit 7-2 OUE
1) Remove the connector for the compressor (see fig. 57).
2) Pull out the two blue wires connected with the four way valve
(see fig. 57).
3) Pull out connectors of the condenser coil temp.
sensor(T3),outdoor ambient temp. sensor(T4) and discharge
temp. sensor(T5) (see fig. 57).
4) Disconnect the electronic expansion valve wire (see fig. 57).
5) Remove the connector for the DR and reactor (see fig. 57).
6) Then remove the electronic control box (see fig. 57).
Reactor
Compressor
T3, T4, TP
Fig. 57.
NOTICE:
This section is for reference only. Actual unit appearance may vary.
CLIMATE 5000 RAC SINGLE SPLIT (R32) – 6720894076 (2019/08)
4-Way Valve
DR
Electronic Expansion
Valve
4. Sound blanket
WARNING
Recover refrigerant from the refrigerant circuit before removing the
compressor.
NOTICE:
Remove the panel plate, electrical parts, and fan assembly (refer
to 1. Panel plate, 2. Electrical parts, and 3. Fan assembly) before
disassembling sound blanket.
1) Remove the sound blanket (side and top) (see fig. 58).
Sound Blanket (top)
Sound Blanket (side)
Fig. 58.
NOTICE:
This section is for reference only. Actual unit appearance may vary.
Maintenance and Disassembly
33