Bosch CLIMATE 5000 Service Manual page 23

6) Disconnect the wires. Then remove the electronic main board (see
fig. 22).
Fig. 22.
7) Remove the fixing screw, then remove the capacitor of fan motor
(see fig. 23).
Capacitor of Fan Motor
Fig. 23.
NOTICE:
This section is for reference only. Actual unit appearance may vary.
CLIMATE 5000 RAC SINGLE SPLIT (R32) – 6720894076 (2019/08)
Swing Motor
Applicable to AC Motor Only
Indoor Fan Motor
Display Board
Pipe Temperature Sensor
Room Temperature Sensor
3. Evaporator
NOTICE:
Remove the front panel and electrical parts (refer to 1. Front panel and
2. Electrical parts) before disassembling evaporator.
1) Disassemble the pipe holder located at the rear of the unit (see
fig. 24).
Pipe Holder
Fig. 24.
2) Remove the screws on the evaporator located at the fixed plate
(see fig. 25).
Screws
Fig. 25.
3) Remove the two screws on the evaporator located at the base of
the bearing side (see fig. 26).
Screws
Fig. 26.
Maintenance and Disassembly
23