Suzuki 2009 Grand Vitara Owner's Manual page 104

Engine Block Heater: 1
Using the Transmission: 10
OPERATING YOUR VEHICLE
of the remote controller may be unreli-
able.
NOTE:
• If the battery of the remote controller
runs down or there are strong radio
waves or noise, the operating range may
be narrower or the remote controller may
be inoperative.
• If the remote controller is too close to the
door, it may not operate.
• The ignition switch may not turn when
the remote controller is on the instru-
ment panel, in the glove box, in a stor-
age compartment, in the sun visor or on
the floor.
CAUTION
The remote controller is a sensitive
electronic instrument. To avoid dam-
aging the remote controller:
• Do not expose it to impacts, mois-
ture or high temperature such as by
leaving it on the dashboard under
direct sunlight.
• Keep the remote controller away
from magnetic objects such as a
television.
3-5
You can also turn the ignition switch by
inserting the ignition key into the slot.
If you leave any of the doors open with the
ignition switch in the "ACC" position for a
while (and no key inserted), the engine
may not start when you turn the ignition
switch to "START". If the engine does not
start, close all doors completely or turn the
ignition switch back to the "LOCK" position,
then start the engine.
The ignition switch has the following four
positions:
LOCK (1)
This is the normal parking position. It is the
only position in which the key can be
removed. It locks the ignition, and prevents
normal use of the steering wheel.
For vehicles with an automatic transmis-
sion, the gearshift lever must be in the "P"
(Park) position to turn the key to the
"LOCK" position.
To release the steering lock, turn the igni-
tion switch clockwise to one of the other
positions. If you have trouble turning the
ignition switch to unlock the steering, try
turning the steering wheel slightly to the
right or left while turning the switch.
• Manual transmission vehicle
You must push in the ignition switch to
turn it from the "LOCK" position to the
"ACC" position. To return to the "LOCK"
position from the "ACC" position, turn the
ignition switch counterclockwise while
pushing in the switch.
• Automatic transmission vehicle
To turn the ignition switch, push the
switch.
ACC (2)
Accessories such as the radio can oper-
ate, but the engine is off.
79K20-03E