Dips Settings - Bodet Rangee BTX 6000 Installation Manual

2.6 DIPs settings

Standby mode (time display) is active.
1/ Open the XTREM console:
- Unfasten the 4 screws on the front panel.
- Remove the bottom of the front panel, taking care not to pull on the internal wiring.
- Tilt the front panel on one side of the bottom in order to access the console's DIPs.
2/ Set the DIPs according to your installation following the examples shown in the table on the next
page.
3/ Consoles must always be paired with their BTX6015:
- Press and hold START for 3 seconds.
Note: do not perform this parameter setting for an installation with a single panel and a single
console: in this case the DIP configuration is carried out in our factory.
This setting is recommended for using BTX6015 Xtrem up to 7 terrains maximum.
The allocation of an Xtrem console with a BTX6015 is done without pairing: the configuration of the
DIPs makes it possible to associate a desk with its board.
Standby mode (time display) is inactive.
The Xtrem desk can be associated with an Easylive tablet.
4/ Open the scoreboard by unfastening the two screws on one side of it and then slide out the glass,
taking care not to damage the LEDs on the display.
13