Specifications; Intended Use - Makita HS004G Instruction Manual

SPECIFICATIONS

Model:
Blade diameter
Max. Cutting depth
No load speed
Rated voltage
Overall length
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
•
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Wear safety glasses.
Only for EU countries
Ni-MH
Li-ion Due to the presence of hazardous com-
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and electronic
appliances or batteries with household
waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and on accumulators and batteries
and waste accumulators and batteries,
as well as their adaptation to national law,
waste electrical equipment, batteries and
accumulators should be stored separately
and delivered to a separate collection point
for municipal waste, operating in accor-
dance with the regulations on environmen-
tal protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
at 0°
at 45° bevel
at 48° bevel
with BL4025
with BL4040
60.0 mm - 62.5 mm
43.0 mm - 44.5 mm
41.0 mm - 42.0 mm
D.C. 36 V - 40 V max
BL4020 / BL4025 / BL4040* / BL4050F*
* : Recommended battery
DC40RA / DC40RB / DC40RC

Intended use

The tool is intended for performing lengthways and crossways
straight cuts and miter cuts with angles in wood while in firm
contact with the workpiece. With appropriate Makita genuine
saw blades, other materials can also be sawed.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-5:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used
especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is run-
ning idle in addition to the trigger time).
2 ENGLISH
HS004G
185 mm - 190 mm
-1
6,000 min
322 mm
337 mm
4.4 - 5.0 kg
) : 93 dB(A)
pA
) : 104 dB (A)
WA