Table of Contents
Advertisement
Selector lever position indicator (AT
vehicles)
This indicator shows the position of the selector lever.
Turn signal indicator lights
These lights show the operation of the turn signal or
lane change signal.
If the indicator lights do not blink or blink rapidly, the
turn signal bulb may be burned out. Replace the bulb
as soon as possible. Refer to the "Replacing bulbs"
section in chapter 11.
High beam indicator light
This light shows that the headlights are in the high
beam mode.
This indicator light also comes on when the headlight
flasher is operated.
Cruise control indicator light
The cruise control indicator light comes on when the
ignition switch is turned to the "ON" position and goes
out after about three seconds.
This light comes on when the "CRUISE" main switch
is pressed.
If it flashes during driving, deactivate the cruise control
UG3030AA
system and contact your SUBARU dealer for an in-
spection. Refer to "Cruise control" in Chapter 7 for the
deactivation procedure of the cruise control system.
Cruise control set indicator light
The cruise control set indicator light comes on when
the ignition switch is turned to the "ON" position and
goes out after about three seconds.
This light comes on when vehicle speed has been set.
Instruments and controls
– CONTINUED –
3-27
Advertisement
Chapters
Table of Contents
