Si-Drive Indicator Light (Wrx Sti); Shift-Up Indicator Light (Wrx Sti); Selector Lever And Gear Position Indicator (At Vehicles); Turn Signal Indicator Lights - Subaru 2009 Impreza Owner's Manual

& SI-DRIVE indicator light
(WRX STI)
1) Intelligent (I) mode
2) Sport (S) mode
3) Sport Sharp (S#) mode
This light indicates the current SI-DRIVE
mode.
For details of SI-DRIVE mode, refer to "SI-
DRIVE (WRX STI)" F7-29.
&
Shift-up indicator light
(WRX STI)
When the ignition switch is turned to the
"ON" position, the indicator light illumi-
nates for 2 seconds, and then turns off.
While selecting the Intelligent (I) mode of
SI-DRIVE, this indicator light illuminates
and informs the driver about the upshift
timing for fuel-efficient driving.
& Selector lever and gear posi-
tion indicator (AT vehicles)
When the ignition switch is turned to the
"ON" position, all of the selector lever and
gear position indicators illuminate for 2
seconds, and then the indicator shows the
position of the selector lever.
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to
"Automatic transmission" F7-23.
Instruments and controls
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to "Replacing bulbs" F11-48.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
&
Cruise control indica-
tor light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the "ON" position and turns off after
approximately 3 seconds.
This light illuminates when the "CRUISE"
main switch is pressed.
If you press the main switch button while
turning the ignition switch "ON", the cruise
control function is deactivated and the
"CRUISE" indicator light flashes. To re-
activate the cruise control function, turn
the ignition switch back to the "Acc" or
– CONTINUED –
3-29