Advertisement
CHAPTER 2. CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
1. CONNECTION, POWER ON/OFF
CONNECTING THE MONITOR TO A POWER SOURCE
(AND DIGITAL SIGNAL CABLING)
Use only the AC adapter supplied.
Note: Do not over bend the cable or give excessive stress to the
cable or sandwich the cables between covers. Otherwise a
breaking of a wire may be occur.
1. Remove the rear cover (a).
Hold both lower sides of the cover and slowly pull the cover
upwards.
Cover(a)
2. Remove the cover (b).
Pull slowly the upper sides of cover toward you while pushing the
marks.
Cover(b)
3. Remove the cover (c).
Pull slowly toward you while pushing both inner sides of the cover.
Cover(c)
4. Mounting the AC adapter
1) Bend lightly the root part of the cord. (Do not over bend the
cord.)
2) Insert the root part of outlet cord until it goes out partly, from
the round hole. And then slowly put down the AC adapter.
Please check whether AC adapter is placed horizontally within the
both fixing rib.
5. Connecting AC adapter
1) Insert the cord into the cord holder.
2) Bundle cord and hang it on the cord hook.
3) Connect outlet plug to DC-IN connector.
Hook
2 – 1
LL-T1512W
AC adapter
Fixing rib
Cord holder
Advertisement
