Troubleshooting Guide - Wen PL1252 Instruction Manual

CLEANING THE PLANER
Keep planer clean of any wood chips, dust, dirt or debris. We strongly recommend always using a dust collection
system. Make sure to clean out the planer after every use.
After 10 hours of operation, the drive chains and sprockets should have wood chips, dust and old grease removed.
While wearing ANSI-Z87.1-approved safety glasses, use a couple puffs of compressed air (do not exceed 50 PSI)
to blow dust and chips out of the gearbox and drive chains.
Use common automotive bearing grease to lubricate all drive chains and sprockets. Spray the gearbox with a light
coat of dry lubricant. Clean the table and infeed / outfeed rollers using a soft, damp cloth. Do not use any waxes,
oils or solvents on the table.
NOTE: The buildup of dust, wood shavings, and other debris can significantly shorten the planer's useful life. Keep
your planer clean! Failure to do so will void the warranty.
WARNING! Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by an authorized technician. For any questions, please contact our customer
service at 1-(800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com.
PROBLEM
Machine does not start.
Material does not feed
properly.
18
MAINTENANCE

TROUBLESHOOTING GUIDE

CAUSE
Machine is not plugged in.
Wrong extension cord size used.
Power outlet does not have power.
Safety key not installed.
Breaker tripped.
Worn carbon brushes.
Dull blades.
Excessive material has built up in the
dust chute.
Broken gearbox or drive chain.
SOLUTION
Plug machine in.
Use properly-sized extension cord (see
chart on p. 7).
Check power outlet for power. Check
breaker for associated circuit. Contact
a professional electrician if necessary.
Install safety key.
Reset breaker.
Replace carbon brushes.
Check blades. Rotate or replace as
necessary.
Clean out the dust chute. Always use a
dust collection system.
Contact customer service at 1-800-
232-1195 for assistance.