Saab 2000 9-5 2.3 Turbo Ecopower Owner's Manual page 58

58 Instruments and controls
Resetting values
To reset the values, press CLEAR for at
least four seconds.
The following functions will be reset
simultaneously:
• Estimated range on remaining fuel
(function based on a fuel consumption of
28 mpg).
• Average fuel consumption.
• Average speed.
• Arrival time (function based on current
speed).
Programmed values for DIST, ALARM and
SPD W will not be reset (see the respective
function).
CHECK messages
When the engine is started, CHECKING will
appear on the display for about four sec-
onds, while the SID checks are being per-
formed.
When a CHECK message is generated
while the car is being driven, a chime will
sound, INFO DISPL will come on on the
main instrument panel, and the message
will appear on the SID. The number of mes-
sages that can be displayed by the SID
varies with the specification of the car.
If more than one CHECK message has
+
been generated, the symbol will appear to
the left of the text on the display. The mes-
sages appear in order of priority.
If a new fault occurs while another message
is being displayed, the message relating to
the new one will appear for 10 seconds,
after which the display will return to the ear-
lier one.
Press CLEAR once to acknowledge a mes-
sage, whereupon it will be cleared from the
display. It will not be displayed again before
the ignition has been switched off and then
on again.
The following messages may be displayed:
Message
FRONT LIGHT FAILURE
REAR LIGHT FAILURE
FOG LIGHT FAILURE
BRAKE LIGHT FAILURE
1)
TEST BRAKE LIGHTS
WASHER FLUID LEVEL LOW
FILL COOLANT FLUID
REPLACE KEY BATTERY
KEY NOT ACCEPTED
SERVICE THEFT ALARM
TRANSMISSION OVERHEAT-
ING
TIGHTEN FUEL FILLER CAP
2)
TIME FOR SERVICE
See
page
182
185
186
185
185
181
174
35
42
42
141
134
218