Table of Contents
Advertisement
Entering manual defrost mode
To initiate a manual defrost press and hold the
control will read "dEF" while the button is being held. The defrost is initiated when the
defrost mode indicator
return to reading the set point. when the defrost mode indicator
is complete and the compressor will turn back on illuminating the compressor run
indicator
.
Error codes
It is possible for error codes to be displayed on the control screen. In the event of a
malfunction an alarm will sound and the alarm indicator
display. An error code or codes will flash intermittently on the display. If there are
multiple codes, the display will continuously cycle through them. The following photo
shows error code "E0" as an example.
Mute: You may mute the alarm by pressing and releasing the wrench button. The red ringing bell
and all error codes will still be displayed. When the fault is remedied the control will return to
normal operation and will automatically clear the codes from the display.
Carel Control
EO = Air sensing probe - Open or shorted
E1 = Evap. coil probe - Open or shorted
IMSS E3265
illuminates on the display. The control display will then
button approx. 5 seconds. The
turns off the defrost
will be displayed on the
- 20 -
Advertisement
Table of Contents
