Configuring The Loudspeaker Using The Ir Eye - Meridian DSP730 User Manual

Configuring the loudspeaker using the IR eye

Some settings can be changed by sending commands from a
Meridian System Remote (not supplied) directed at the IR eye
while powering-up the loudspeaker. The status of the setting
is indicated by flashing indicators behind the lens of the IR eye
immediately after the operation.
Centre mode
Centre mode can be toggled off and on by holding down the
Left-cursor key (<) while powering-up the loudspeaker.
Status
White indicator flashes four times Centre-mode activated
Blue indicator flashes four times
IR eye
The IR eye on the front-panel of the loudspeaker can be
enabled or disabled by holding down the Next and Previous
keys respectively while powering-up the loudspeaker.
DSP730 In-Wall Digital Active Loudspeaker User Guide
Description
.
Centre-mode
deactivated
.
Key and status
Next key
White indicator flashes twice
Previous key
Blue indicator flashes twice
Factory reset
A factory reset can be performed by holding down the Stop
key while powering-up the loudspeaker.
Status
White indicator flashes three
times
Description
IR eye on
.
IR eye off (default)
.
Description
The loudspeaker has
been reset
.
3